DriverFound Posted April 4, 2014 Share Posted April 4, 2014 Anyone have a Tempe sensor paired with a 64st? Problem with mine is the 64st cannot/does not re-connect to Tempe sensor at power on. I'd have to go to Setup and set Tempe sensor to Off the On again for it to re-connect. Tempe sensor is working properly. My other 2 devices connect to it without issue. Garmin support recommended a Master Reset which didn't fix the issue. Quote Link to comment
DriverFound Posted April 4, 2014 Author Share Posted April 4, 2014 I exchanged for another 64st today. It has the same issue (in both firmware 2.40 and 2.60) Quote Link to comment
+coshida Posted April 5, 2014 Share Posted April 5, 2014 I exchanged for another 64st today. It has the same issue (in both firmware 2.40 and 2.60) I have similar issues with a Dakota 20. It connects once to Tempe or a Chirp sensor, then refuses to reconnect. Firmware is the latest 5.80. It's annoying as the Etrex 30 connects every time. The Tempe is part of a weather monitoring system, so good data-comms would be useful. Quote Link to comment
DriverFound Posted April 11, 2014 Author Share Posted April 11, 2014 Here's the response I got from Garmin Tech Support. We were able to replicate the issue in-house. Therefore, I recommend to check regularly for software updates for this device. There is no timeline for this issue but it will likely be resolved with software updates. Quote Link to comment
+coshida Posted April 12, 2014 Share Posted April 12, 2014 Good old Garmin-speak: 'likely be resolved'. Tempe (and Chirp) work well on the Etrex. I sometimes get the feeling that Garmin staff work in sealed boxes so that they can't communicate with each other. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.