Jump to content

Magellan explorist gc won't boot up


scropenoggin

Recommended Posts

Hello all, hope someone can help with this. My explorist gc is refusing to boot up-it displays the magellan logo and the compass which gets to about 2 o'clock and then stops. That's it! It has been updated (this took ages, and several failed attempts using Mac and 3 versions of windows) and had been working fine-the lock-up has happened after a few days of not being used. I've tried the joystick up / menu button/power button trick with no joy as yet. I suspect that there may well be little else to say, but has anyone else managed to solve this issue?

I have to say, the unit is moderately tidy to use, but for me it's outrageous that the update process to 2.15 has been such a mess, and the Mac compatibility issues would prevent me recommending this unit. Back to the old etrex camo for me!

Link to comment

I've tried the joystick up / menu button/power button trick with no joy as yet.

 

What do you mean by no joy as yet? Have you been able to get it in to service menu?

If you were able to get to the service menu what did you do to attempt to fix it?

 

Are you following all of these step in this order?

 

1. Pull the batteries and replace with fresh ones. (If you are sure that you are using new batteries. Remove them, count to 10, then replace them).

2. Connect the usb cable between the GPS and your computer (with the explorist off).

3. Hold menu+up+power and the unit will start up in disk access mode (keep them all pressed in until you get a menu on the screen).

If you are having trouble with step 3 one trick is to press menu and up buttons first. Then once you are sure you have both of them pressed, press and hold the power button while continuing to hold the other two buttons. Remember not to let go until after the menu screen appears.

4. Once it starts up, browse the device in the windows explorer (or mac equivalent).

5. Go into Geocaches folder and move all the files in there to your pc (make a folder in your my documents to store them). Double check to make sure that there are no files in the Geocaches folder on the GPS.

6. Go into the Waypoints folder and move all these file as well (keep them separate from the geocache files from above). Double check to make sure that there are no files in the Waypoints folder on the GPS.

7. Eject (safely remove, etc) the GPS and pull the usb plug. The unit will reboot normally.

Link to comment

I've tried the joystick up / menu button/power button trick with no joy as yet.

 

What do you mean by no joy as yet? Have you been able to get it in to service menu?

If you were able to get to the service menu what did you do to attempt to fix it?

 

Are you following all of these step in this order?

 

1. Pull the batteries and replace with fresh ones. (If you are sure that you are using new batteries. Remove them, count to 10, then replace them).

2. Connect the usb cable between the GPS and your computer (with the explorist off).

3. Hold menu+up+power and the unit will start up in disk access mode (keep them all pressed in until you get a menu on the screen).

If you are having trouble with step 3 one trick is to press menu and up buttons first. Then once you are sure you have both of them pressed, press and hold the power button while continuing to hold the other two buttons. Remember not to let go until after the menu screen appears.

4. Once it starts up, browse the device in the windows explorer (or mac equivalent).

5. Go into Geocaches folder and move all the files in there to your pc (make a folder in your my documents to store them). Double check to make sure that there are no files in the Geocaches folder on the GPS.

6. Go into the Waypoints folder and move all these file as well (keep them separate from the geocache files from above). Double check to make sure that there are no files in the Waypoints folder on the GPS.

7. Eject (safely remove, etc) the GPS and pull the usb plug. The unit will reboot normally.

 

Thank you-I have already tried something similar, but I suspect I wasn't waiting long enough. I'll give it another go- thanks to all, will let you know what happens!

Link to comment

Ok, have just tried to get into the service menu by doing the up joystick/menu/power on combination-have held this for 10seconds with no joy-the compass thing stops at 10past and that's it. It doesn't get far enough to be recognised as a disk. It had been working perfectly! I can't think of anything else to try, but I'll not give up totally-it's not a bad unit when it's working. Thank you to everyone who has tried to help, if you have anything else to add I'll happily give it a go!

Link to comment

I just tried pressing MENU+UP+POWER on my eXp GC and guess what. It didn't work. A played around a bit and discovered something. If you are using version 2.15 of the firmware they changed the procedure a bit. You now have to push the joystick to the left. Give MENU+LEFT+POWER a try. The other steps should be the same.

Link to comment

I just tried pressing MENU+UP+POWER on my eXp GC and guess what. It didn't work. A played around a bit and discovered something. If you are using version 2.15 of the firmware they changed the procedure a bit. You now have to push the joystick to the left. Give MENU+LEFT+POWER a try. The other steps should be the same.

Thanks for the help-this hasn't worked either! I'll give Magellan a ring sometime today and see what they advise. I'm fairly certain it's out of warranty, and don't have any paperwork for it in any case, so I'll have to grin and bear it I guess.

Thanks for all the input, I'll post here if anything else transpires.

Link to comment

I just tried pressing MENU+UP+POWER on my eXp GC and guess what. It didn't work. A played around a bit and discovered something. If you are using version 2.15 of the firmware they changed the procedure a bit. You now have to push the joystick to the left. Give MENU+LEFT+POWER a try. The other steps should be the same.

Thanks for the help-this hasn't worked either! I'll give Magellan a ring sometime today and see what they advise. I'm fairly certain it's out of warranty, and don't have any paperwork for it in any case, so I'll have to grin and bear it I guess.

Thanks for all the input, I'll post here if anything else transpires.

Well, finally got round to phoning Magellan, not a lot of help. I've replaced the gc with an etrex 30- much better. I' ll think very carefully before buying magellan again.

Link to comment

I wanted to delete my personal info on my magellan explorist gc and not knowing what i was doing i end up deleting all my info now when i open the gps i get one window with those word on top of it.factory-run-other-help-x .I have try to click to every one of those window with no respond ,what did i do wrong. 

Edited by gerchan
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...